Bulova FS00/01/10 User Manual download pdf

FEATURES

1. Hours, minutes, seconds and date display.

2. 60 minute Chronograph (CHRONO) with minutes and

seconds display.

3. 24 hour hand, permanently synchronized with the normal

12 hour hand.

A. SETTING THE TIME

1. Pull the crown out to position “3” (See diagram). If the crown has

a “screw-down” lock, then unscrew the crown lock first by turning

the crown toward you, then pull it to position “3”. Do not forget to

screw the crown back “IN” after all setting is completed.

2. Turn the crown towards you (hands moves clockwise) until the

date changes at approximately midnight.

3. Continue turning the hour and minute hands to the correct time.

If it is afternoon you must go past 12 o’clock again (noon) to set

the correct time.

4. When the correct time is set,push crown back to position “1”.

B. SETTING THE DATE

1. Pull crown to position “2”(See proceeding diagram).The watch

will continue to run.

2. Turn the crown away from you until the correct date appears.

3. Once the date is set, push the crown back to position “1”.

Note: Do NOT set the date between the hours of 8:00 PM and

3:00 AM.This would not damage the watch,but the date may need

to be reset later.

C. CHRONOGRAPH (CHRONO) ADJUSTMENT

If the chrongraph second hand is not positioned at the proper

starting position (12 o’clock or “zero” position), use the below

procedure.It does not need to be repeated unless the watch

receives an impact sufficient to move the hand out of position, or

the Battery has been changed.

1. Pull crown out to position “3”.

2. Push button “A” to move the Chrono Second hand (long hand) to

the “0” or 12 o’clock position. Each button push will move the

hand one step – BUT holding the button down will advance the

hand rapidly.

3. Push crown back to position “1”.

D. USING THE CHRONOGRAPH (CHRONO)

Note: The maximum chrono reading is 60 minutes, However the

chrono will continue running once 60 minutes has passed. The

resulting one hour periods may be added together mentally to keep

track of longer periods.

For example – If you know that approximately one hour has

passed since you started the chronograph, and the chrono reads

25 minutes, then you know that the chrono has been running 60

minutes plus 25 minutes, which is one hour and 25 minutes.

1. Push Button “A” to start the chronograph. Push button “A” again

to stop the chronograph.

2. Push button “B” to return the two chronograph hands to the

“Zero” or starting point.

3. The Chronograph can be stopped and started again

(Button “A”), repeatedly, to “ADD” times together.

BOOK NO. 561/598 Chrono FS00/01/10

Watch Setting Guide

4/2007

1 2 3

Watch Setting Guide 1

Summary of Contents

Page 1 - Watch Setting Guide

FEATURES 1. Hours, minutes, seconds and date display. 2. 60 minute Chronograph (CHRONO) with minutes and seconds display. 3. 24 hour hand, permanently

Page 2

FONCTIONS1. Affichage des heures, des minutes, des secondes et de la date.2. Chronographe 60 minutes (CHRONO) avec affichage des minutes et des second

Page 3

CARACTERÍSTICAS1. Presentación de las horas, los minutos, los segundos y la fecha.2. Cronógrafo de 60 minutos con presentación de minutos y segundos.3